CardioSoft - Jaken Medical...

Resting ECG: Post Test Review
F
G
H
I
Select if you wish to adjust the T-wave offset mark (see “Adjusting the T-offset
Mark” on page 5-19).
Measurement mark.
Menu for selection of the leads to be reanalyzed.
Table showing time intervals and position of the cursor in mV.
Performing Reanalysis
1. Click the measurement mark and hold the mouse button depressed.
2. Move the measurement mark to its new position and release the
mouse button.
3. Adjust the other marks in the same way.
4. Click ECG Analysis.
5. Click Reset and ECG Analysis if you wish to restore the previous
analysis results.
Note
The P-onset and P-offset markers may be dashed, e.g. in the presence
of atrial fibrillation. This indicates that the program was unable to
locate the exact beginning and end of the P wave. In this case you can
click the marks and drag them to the correct position; the marks are
now solid instead of dashed. It is possible to restore the marks to the
original position by clicking them again.
5-18 CardioSoft Revision A
2023324-053