CardioSoft - Jaken Medical...

Product Overview: Putting the System Into Service
Putting the System Into Service
The software is a Windows-based program. Its scope can be expanded by
activation of individual optional programs. This manual describes the
program with all options included. If you have not purchased one or the
other option, simply skip the corresponding sections.
Access to the program is restricted to registered users. At the time a user
is registered, the password and privileges are assigned (technician,
physician, with or without the right to edit data, etc.).
Mains Connection, Power Up, Functional Test
1. Before powering the system up for the first time, read the safety
information in section “Safety Information” on page 1-6.
2. Turn on the PC, the monitor and, if used, the bicycle ergometer or
treadmill, electrocardiograph and printer.
The program will start up automatically. When you see the initial screen
(see “Initial Screen” on page 2-13) and no error message appears, the
system is operational.
Note
Do not run more than one additional Windows-based program at
the same time as CardioSoft.
The screen saver is automatically disabled during ECG
acquisition.
When using the program for the first time, select the size of your
monitor screen (“General Tab” on page 11-41).
Disable all energy save modes (BIOS, Windows).
Connect the printer(s) to parallel ports only.
Unlock the purchased optional software programs as described in
section “Option Code Tab” on page 11-57.
Scan the hard drive for viruses once a week.
Do not turn off the PC until you have properly exited from the
program and from Windows.
Run a functional test on a regular basis (about once a month);
this includes an inspection of the cables and other accessories for
signs of damage.
Warning
Simulated Patient Data — To avoid the possibility of
misinterpreting patient information, enable the
simulated Test Patient data for demonstration purposes
only.
2-12 CardioSoft Revision A
2023324-053