CardioSoft - Jaken Medical...

Product Overview: PC Setup
Warning
Patient Hazard — Always connect the CAM-14
acquisition module to the CAM-USB interface box, never
directly to the PC.
Always attach the CAM-USB interface box to a suitable
place (e.g. on the PC).
Shock Hazard / Equipment Damage — The patient signal
input is a high-insulation port and it is defibrillationproof
(CAM-14, type BF / CORINA, type CF). This type of
input guarantees patient safety and protects the
equipment during defibrillation and HF surgery.
Nevertheless, extreme care should be exercised when a
defibrillator or HF surgery equipment is used on a
patient connected to other devices. As a general rule, the
distance between the ECG electrodes and the
defibrillation or HF surgery electrodes should not be less
than 15 cm. If this is not ensured, temporarily disconnect
the patient cables while using the defibrillator or the HF
surgery equipment. It is very important that conductive
parts, such as connectors, electrodes, transducers, do not
come into contact with other grounded, conductive parts
when connected to the isolated patient input. Such
contact would bridge the patient's isolation and cancel
the protection provided by the isolated input. In
particular, there must be no contact of the neutral
electrode and ground.
Note
Set up the device so that the operator has a clear,
unobstructed view of the control panel.
Only persons with the required training and expertise are
authorized to use medical electrical equipment such as a PC
with CardioSoft.
Revision A CardioSoft 2-7
2023324-053