CardioSoft - Jaken Medical...

Product Overview: PC Setup
Caution
Proper Leadwire Connection — Improper connection will
cause inaccuracies in the ECG.
Trace each individual leadwire from its acquisition
module label to the colored connector and then to the
proper electrode to ensure that it is matched to the
correct label location.
4. Connect the CAM-USB or the CAM-USB A/T interface box to the
USB port of your PC. Do not connect the CAM-USB interface box to a
USB hub or an extension cable.
5. Connect the AC power adapter to the CAM-USB A/T interface box.
Pull back the coupling sleeve to disconnect.
6. Suction tubing connects here (CAM-USB A/T KISS interface box
only).
7. Trigger and analog signal outputs.
Note
The ECG signal input is isolated and defibrillation-proof if used
in conjunction with the CAM-14 acquisition module / USB or
USB A/T interface box (type BF).
Before starting the program, check that the CAM-USB or CAM-
USB A/T interface box is connected to the PC. If this is not the
case, the system cannot read the internal serial number and all
option codes will become invalid.
CORINA (CardioSoft V6.0 only supports CORINA models 101 118 3x)
CORINA is powered from a special AC power adapter. A second version
of the acquisition module is available for use with the electrode
application system.
1. Turn off the PC and connect the acquisition module to the parallel
port of your PC.
2. Connect the cable of the AC power adapter.
3. Connect the patient cable to the acquisition module.
4. If you purchased an acquisition module that supports the electrode
application system, connect the pneumatic lead to the acquisition
module. (Refer to the Operator's Manual of the Electrode Application
System.)
Note
The ECG signal input is isolated and defibrillation-proof if used
in conjunction with the CORINA acquisition module (type CF).
2-6 CardioSoft Revision A
2023324-053