CardioSoft - Jaken Medical...

Miscellaneous: Installing the Program
Installing the Program In a Network Environment
Note
The installation of the program in a network should be referred
to authorized staff. Incorrect installation of the program may
cause loss of data and other network problems.
The program must be closed at all workstations while it is being
installed in the network.
Preparing the System
If you want to use the program in a network environment, the network
administrator must first set up the network accordingly, i.e.,
the workstations must be integrated in the network
the users must be registered with the appropriate privileges
Proper communication with the server where all patient data will be
stored is of utmost importance. The users must have read and write
privileges for the drive where CardioSoft will be installed. In the
network, the users must be granted all read and write privileges for that
drive. The software supports the common Ethernet network protocols.
For communication with the MUSE CV database system, select the TCP/
IP protocol. When starting CardioSoft, the network address of the MUSE
server must be available.
The Remote View function is also operational when the software is
installed locally.
You are advised to have the correct IP address or network names of the
remote exercise test stations ready when setting up the network and
before starting Remove View for the first time.
Install the recommended printer drivers only (see “Printer Installation”
on page 2-4). Other printer drivers, in particular those from some printer
manufacturers, my cause data communication problems with the
acquisition module.
Program Installation
Installing the program in a network is basically similar to installing it
locally, only the target directory CARDIO is not on the local hard drive,
but on a network server drive. The link to the network drive must be
established before installing the program, so that the drive/directory can
be found on installation. Important: All program users must have access
to this drive for read and write operations.
Note
CardioSoft must be installed at each individual workstation, but not
on the network server.
It is also necessary to install CardioSoft on the CardioSoft Web PC.
The target directory is the same server directory in each case. The
installation program automatically detects the files already installed
and will only add specific information on the local PC. Do not use
CardioSoft on the network server.
B-26 CardioSoft Revision A
2023324-053