CardioSoft - Jaken Medical...

More documents

Recommendations

Info

Miscellaneous: Connecting Peripheral Devices Treadmills Connect the treadmills to the COM 1 or COM 2 port. Model Treadmills without digital communication interface GE Medical Systems Information Technologies treadmills 1800 1900 T2000/T2100 T2100 Trackmaster TMX 425 Trackmaster TM400 internal treadmill Series 2000 T2100 TMX 425 TM 400 Configuration Note Other bicycle ergometers and treadmill models with an analog port can be connected to the analog output of the system. Connecting the ERGOLINE 900/900 L/900 EL Ergometers to the System Set the following parameters at the ergometer: ECG type: P10 Baud rate: 4800 The ergometer software must be version V436 or V236; ergometers with a 4-button control panel must be software version 752 or M343. Plug the round connector of the connecting cable into the J10 / RS 232 port of the ergometer and the other end into the COM 1 or COM 2 port of the system. B-4 CardioSoft Revision A 2023324-053
Miscellaneous: Connecting Peripheral Devices Putting the Lode Excalibur Ergometer Into Service Every time you turn on the ergometer, the TERMINAL option must be selected in the ergometer menu and confirmed with Enter. Then the display will show the workload and pedal speed. THEN start the system. Otherwise an error message will appear, saying "No communication with ergometer/treadmill". Putting the EC 1200 Ergometer Into Service The EC 1200 bicycle ergometer only supports graded phases. When first activating the Protocol Editor, a single line will be displayed for Basic Load Load Increase Stage Time Number of Stages ECG Recording Interval, and BP Interval for each phase. Basic Load is the load level at the beginning of a phase. When the Stage Time has elapsed, the next stage begins and the load increases by the value entered at Load Increase. At Number of Stages you enter the number of stages for a phase. The configured ECG Recording Interval and BP Interval ensure that ECG recordings and BP measurements are initiated at the appropriate point in time before the end of a stage. The first ECG recording and BP measurement are fixed and cannot be changed. Enter a minimum value of 10 seconds for the ECG Recording Interval and of 1 minute for the BP Interval. The ECG Recording Interval and the BP Interval will be maintained until the end of the phase. These values can thus be set independently of the Stage Time. Each time the program advances to the next stage both intervals are reset to synchronize them with the new stage. A BP Interval must be entered in the pretest phase to take a blood pressure measurement before the test. Since no further BP measurements are required in pretest, the default BP Interval is 99 minutes. If you do not want to take a pretest BP measurement, change this value to 00:00:00. A BP monitor connected directly to the EC 1200 will take the blood pressure at the beginning of each phase. The arrow buttons W+ and W– change the load setting to the value of the next or previous stage. All other protocol parameters remain unchanged. The load for subsequent stages increases accordingly. Revision A CardioSoft B-5 2023324-053
Page 1 and 2:
CardioSoft ® Version 6.0 Operator'
Page 3 and 4:
CE Marking Information CE Marking I
Page 5 and 6:
Contents 1 Introduction . . . . . .
Page 7 and 8:
Full Disclosure ECG . . . . . . . .
Page 9 and 10:
10 EMR Interface . . . . . . . . .
Page 11 and 12:
System Maintenance . . . . . . . .
Page 13 and 14:
1 Introduction Revision A CardioSof
Page 15 and 16:
Introduction: License Agreement Lic
Page 17 and 18:
Introduction: About This Manual Con
Page 19 and 20:
Introduction: Safety Information
Page 21 and 22:
Introduction: Safety Information Wa
Page 23 and 24:
Introduction: Safety Information Wa
Page 25 and 26:
Introduction: Safety Information Eq
Page 27 and 28:
Introduction: Service Information S
Page 29 and 30:
2 Product Overview Revision A Cardi
Page 31 and 32:
Product Overview: PC Setup PC Setup
Page 33 and 34:
Product Overview: PC Setup Connecti
Page 35 and 36:
Product Overview: PC Setup Warning
Page 37 and 38:
Product Overview: PC Setup Installi
Page 39 and 40:
Product Overview: PC Setup Softkeys
Page 41 and 42:
Product Overview: Putting the Syste
Page 43 and 44:
Product Overview: Putting the Syste
Page 45 and 46:
Product Overview: Software Features
Page 47 and 48:
Product Overview: Software Features
Page 49 and 50:
3 Preparing the Patient Revision A
Page 51 and 52:
Preparing the Patient: Applying Ele
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Preparing the Patient: Attaching th
Page 63 and 64:
4 Selecting a Patient Record and Te
Page 65 and 66:
Selecting a Patient Record and Test
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
5 Resting ECG Revision A CardioSoft
Page 73 and 74:
Resting ECG: Entering Test Informat
Page 75 and 76:
Resting ECG: Entering Test Informat
Page 77 and 78:
Resting ECG: Recording a Resting EC
Page 79 and 80:
Resting ECG: Recording a Resting EC
Page 81 and 82:
Resting ECG: Post Test Review Post
Page 83 and 84:
Resting ECG: Post Test Review ECG T
Page 85 and 86:
Resting ECG: Post Test Review Measu
Page 87 and 88:
Resting ECG: Post Test Review Reana
Page 89 and 90:
Resting ECG: Post Test Review Adjus
Page 91 and 92:
Resting ECG: Post Test Review Deter
Page 93 and 94:
Resting ECG: Post Test Review Full
Page 95 and 96:
Resting ECG: Post Test Review Repor
Page 97 and 98:
Resting ECG: Post Test Review Copyi
Page 99 and 100:
Resting ECG: Post Test Review 10-Se
Page 101 and 102:
Resting ECG: Post Test Review A B C
Page 103 and 104:
Resting ECG: Post Test Review Zoom
Page 105 and 106:
6 Exercise Test Revision A CardioSo
Page 107 and 108:
Exercise Test: Patient Education Pa
Page 109 and 110:
Exercise Test: Entering Test Inform
Page 111 and 112:
Exercise Test: Entering Test Inform
Page 113 and 114:
Exercise Test: Before the Test C D
Page 115 and 116:
Exercise Test: Before the Test Oper
Page 117 and 118:
Exercise Test: During the Test Pret
Page 119 and 120:
Exercise Test: During the Test Manu
Page 121 and 122:
Exercise Test: During the Test Medi
Page 123 and 124:
Exercise Test: During the Test Tabu
Page 125 and 126:
Exercise Test: During the Test Tren
Page 127 and 128:
Exercise Test: During the Test 12SL
Page 129 and 130:
Exercise Test: During the Test Comp
Page 131 and 132:
Exercise Test: Test End Phase Test
Page 133 and 134:
Exercise Test: After the Test — P
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156:
Exercise Test: Report Formats Repor
Page 157 and 158:
Exercise Test: Monitoring of Remote
Page 159 and 160:
7 Ambulatory Blood Pressure Measure
Page 161 and 162:
Ambulatory Blood Pressure Measureme
Page 163 and 164:
Page 165 and 166:
Page 167 and 168:
Page 169 and 170:
Page 171 and 172:
Page 173 and 174:
Page 175 and 176:
8 Spirometry Test Revision A Cardio
Page 177 and 178:
Spirometry Test: Sensors Sensors Th
Page 179 and 180:
Spirometry Test: Entering Test Info
Page 181 and 182:
Spirometry Test: Conducting Spirome
Page 183 and 184:
Page 185 and 186:
Page 187 and 188:
Page 189 and 190:
Spirometry Test: Post Test Review M
Page 191 and 192:
Spirometry Test: Post Test Review R
Page 193 and 194:
Spirometry Test: Post Test Review C
Page 195 and 196:
9 File Management Revision A Cardio
Page 197 and 198:
File Management: Overview Overview
Page 199 and 200:
File Management: Selecting Patient
Page 201 and 202:
File Management: Viewing, Editing,
Page 203 and 204:
File Management: Sending, Exporting
Page 205 and 206:
10 EMR Interface Revision A CardioS
Page 207 and 208:
EMR Interface: Overview Overview Th
Page 209 and 210:
EMR Interface: Performing an Examin
Page 211 and 212:
11 System Settings Revision A Cardi
Page 213 and 214:
System Settings: Resting ECG Setup
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
Page 221 and 222:
Page 223 and 224:
System Settings: Exercise Test Setu
Page 225 and 226:
System Settings: Exercise Test Setu
Page 227 and 228: System Settings: Exercise Test Setu
Page 243 and 244: System Settings: Ambulatory Blood P
Page 245 and 246: System Settings: Ambulatory Blood P
Page 247 and 248: System Settings: Spirometry Setup M
Page 249 and 250: System Settings: Custom Setups, Fac
Page 251 and 252: System Settings: System Configurati
Page 271 and 272: A Cleaning and Maintenance Revision
Page 273 and 274: Cleaning and Maintenance: Cleaning,
Page 275 and 276: B Miscellaneous Revision A CardioSo
Page 277: Miscellaneous: Connecting Periphera
Page 281 and 282: Miscellaneous: Connecting Periphera
Page 283 and 284: Miscellaneous: Connecting Periphera
Page 285 and 286: Miscellaneous: Application Tips If
Page 287 and 288: Miscellaneous: Reference Value Equa
Page 295 and 296: Miscellaneous: CardioSoft Web Cardi
Page 297 and 298: Miscellaneous: CardioSoft Web Displ
Page 299 and 300: Miscellaneous: Installing the Progr
Page 301 and 302: Miscellaneous: Troubleshooting Trou
Page 303 and 304: Miscellaneous: Troubleshooting Note
Page 305 and 306: Miscellaneous: System Maintenance S
Page 307 and 308: Miscellaneous: ECG Measurement and
Page 309 and 310: C Order Information Revision A Card
Page 311 and 312: Order Information: Order Informatio
Page 319 and 320: Index A Acquisition Module Keys 3-1
Page 321 and 322: Index Power Inlet 2-12 Power Up 2-1
Page 324: 0459 gemedical.com World Headquarte
show all

CardioSoft - Jaken Medical...

Create successful ePaper yourself

Delete template?

Save as template?