CardioSoft - Jaken Medical...

Introduction: Safety Information
Warning
Shock Hazard — Observe the following warnings. Failure
to do so endangers the lives of the patient, the user, and
other persons present.
All modems connected to the system must meet the
requirements of IEC 60950 or UL1950. The specific
regulations valid in your country must also be
observed.
The modem must be installed within the medical
location, but not in the patient vicinity.
Disconnect the patient from the PC while sending
data via the modem.
Devices may only be connected to each other or to
parts of systems when it has been made certain that
there is no danger to the patient, the operator, or the
environment as a result. In those instances where
there is any element of doubt concerning the safety of
connected devices, the user must contact the
manufacturers concerned or other informed experts
as to whether there is any possible danger to the
patient, the operator, or the environment as a result
of the proposed combination of devices. Standards
IEC 60601-1-1/EN 60601-1-1 must be complied with
in all cases.
Liquids must not be allowed to enter the acquisition
module or the CAM USB / CAM-14 interface box. If
liquids have entered the devices, notify service to
have them inspected for damage before using them
again.
Use only the original GE Medical Systems
Information Technologies patient cable.
1-10 CardioSoft Revision A
2023324-053