CardioSoft - Jaken Medical...

Ambulatory Blood Pressure Measurement: Setting Up the Ambulatory Blood Pressure Monitor
Operating Steps
1. Turn the monitor off and on again.
2. Wait for the time to be displayed, then connect the monitor to the PC.
3. Click Connect.
The acquisition screen indicates the memory status of the ambulatory
blood pressure monitor.
Date and time of the monitor A.
Measurement protocol B.
Information whether or not data is stored in the monitor D.
Number of BP measurements and the duration of the protocol C.
A B C
D
182A-BP
4. Click the Clear Data button to delete data stored in the monitor.
Note
If the stored data has not been transferred to the system,
download it as described in the next section.
5. Click Programming to select the protocol.
6. Select the protocol and click Programming.You can choose between
two protocols. Refer to section “Editing the BP Protocol” on page 11-
33 for information on configuring the protocols.
7. Turn the monitor off and disconnect it from the PC.
8. Connect the monitor to the patient (see TONOPORT Operator's
Manual).
Revision A CardioSoft 7-5
2023324-053