CardioSoft - Jaken Medical...

Exercise Test: During the Test
Manual Control
F11: comment Press to enter comments to appear in the Tabular
Summary.
F12: enter BP Press to enter BP readings.
12 lead Press to start an ECG recording (12 leads, 5 seconds
from memory, 5 seconds of real-time data).
recall
Press to print a 10-second delayed recall report.
rhythm
Press to start a continuous rhythm report.
stop writer Press to stop the writer/printer.
medians Press to print a medians report.
arrhy doc
Press to enable or disable the automatic
documentation of arrhythmias.
Note
Cubic Spline / FRF algorithms can delay the rhythm report by
approximately 1 second when enabled.
12SL
F7: grade +
F8: grade -
F5: speed +
or load +
F6: speed -
or load -
hold stage
Press to acquire a 12SL resting ECG with
measurements and interpretation (only in the pretest
and recovery phases).
Press to change the elevation of the treadmill belt.
Press to change the belt speed or ergometer load.
Press to hold the exercise test in the current stage.
Note
In the pretest phase, Shift + pretest or Shift + F1 allow you to
return to the previous stage.
If a bicycle ergometer test is initiated with the F2: exercise
button, the clock will start even when the patient has not yet
begun to pedal.
When the patient reaches the target HR, the HR reading turns
red and an audio signal sounds (if configured, see section
“Miscellaneous 1 Tab” on page 11-24).
Using the treadmill speed and grade buttons during a protocol
puts the treadmill in manual control. The system is no longer
controlled automatically by the protocol. The system will enter a
new stage and the phase name appearing in the Tabular
Summary will be Manual.
Revision A CardioSoft 6-15
2023324-053