Introduction.

Workshop PG5
Welcome
Your PCD:
You can write programs for any of the existing PCD’s:
PCD1
PCD2
PCD4
PCD6
Have a look into the hardware manuals for further information about any of the
PCD’s. Programs written with the PG5 will run on any of the PCD’s.
All the examples are written for a PCD2 or PCD1 with:
• 1 digital input card (E110 or E111 type) in slot 1 (equals address 0..7)
• 1 digital output card (A400 type) in slot 2 (equals address 16..23)
• 1 analogue input card (W100 type) in slot 3 (equals address 32..39)
Further you’ll need a cable PCD8.K111 in order to download the program
into the PCD.
Further
Documentation:
For information about existing hardware refer to:
Documentation CD-Rom: Ordernumber 26/801
© Saia-Burgess Controls Ltd.