Introduction.

Workshop PG5
Additional tools
PG5 does add some instructions into the program code in order to configure
the PCD.
If you upload your code and you make a project, then these instructions will
be uploaded too. Therefore if you build your program again, then the PG5
tries to add these instructions again and this will create an error like:
The instruction concerned are:
DEFVM
DEFTB
DEFTC
Another error you can get is :
Error 369: Absolute address in auto allocation segment: F 7500
You can tell the Software settings not to add
the DEF-Instructions and not to use auto allocation.
With this setting activated the project will
build without errors.
PG5-08-E © Saia-Burgess Controls Ltd. Page 8-20