Introduction.

Workshop PG5
Additional tools
NOTE:
In case you have this message :
Make certain that:
1. Your K111 cable is connected to the right COM port => change the
port in the SETUP.=>
1. The PCD is running
Clarification of
each field in the
Online-Configurator:
• PCD type: Identification of the CPU (Hardware)
• Version: Current firmware version of the connected PCD.
• Program name: Current project in the PCD program memory
• Date: Current date of the PCD hardware clock (if there
is no hardware clock then the date will be 1/1/92
• Time: Current time by the hardware clock
• Day: Current day of week: 1 = Monday, ... 7 =Sunday
• Week: Current week number of current year
• Status: RUN, STOP, HALT or Conditional Run
• CPU: for PCD2 always 0,
for PCD4 0 or 1
for PCD6 0 - 6
• Protocol: PGU direct or S-BUS
• Baud: Transmission speed:
for PGU direct: always 9600 Baud
for S-BUS: 110 – 38,400 Baud
• Station: Station number:
for PGU direct: not relevant
for S-BUS: 0 - 254
PG5-08-E © Saia-Burgess Controls Ltd. Page 8-14