Introduction.

Workshop PG5
Getting Started - Project management
Important
JUMPERS:
There are several jumpers
on the PCD where you
can choose the kind of memory
chip you are using. (Examples:
EPROM, RAM and some times
Flash).
There is a jumper to indicate if
the memory is > < 1Mbit.
Before the settings are
downloaded, the PG5 reads the
position of these jumpers and
compares it with the setting you
have chosen from the list.
2
1
2
Example PCD2:
If you use an additional memory
chip in the socket 1 and you
encounter problems at this stage,
then check the position of these
jumpers!
2
For further information, please refer to the hardware manual.
© Saia-Burgess Controls Ltd Page 1-11