Introduction.

Workshop PG5 Exercise Chapter 7
General questions 1 to 7
1. Which of the following instructions are executed only if the ACCU is
high?
SET RES COM INC STH
2. How can you set / reset and flip the ACCU state?
3. Load the state of the Error-Flag into the ACCU
4. Write a program that corresponds to these two ladder diagrams
Example 4.1: Example 4.2:
I 1 * I 2 + I 3 = O32
I 1 + I 3 * I 2 = O32
5. What would the result in example 4.2 be, if the result of the first logic
combination wouldn’t be saved in a flag:
STH I 1
ORH I 3
ANH I 2
OUT O 32
Instead of =>
STH I 1
ORH I 3
OUT F 0
STH F 0
ANH I 2
OUT O 32
Draw the solution as electrical drawing.
© Saia-Burgess Controls Ltd. Page 7E-1