Introduction.

Workshop PG5
Getting Started - Project management
Individual
Hardware Settings:
We just covered the entry of the default hardware settings. These would be
useful if you had several PCD’s with the same configuration. You could set the
default settings once, and all the others would be configured via the default
settings.
For projects with one or several different PCD’s, we have the individual hardware
settings.
Highlight Hardware, and double click on it.
Enter the PCD type, the memory and the
extension memory. If you are not sure on
on the memory, you can click on Upload
and the PCD will fill in the memory and the
extension memory for you. This is only available
with the individual settings, it is not
available when setting the default settings.
If you are not sure of the
memory of your PCD,
click on Upload, and it
will enter the data for you.
Click on
Upload
again.
When Upload
is complete
click on
l
© Saia-Burgess Controls Ltd Page 1-9