Introduction.

Workshop PG5 Exercise Chapter 4
Highlight and
click on Binary
Hightlight and
click on “And”
You should now have the “And” symbol on the program page. You can move it to
any location on the page by moving your mouse. When you have it where you want
it, click the left mouse button one time, and this will paste the symbol to this location.
Move the mouse vertically to choose the number of inputs you want. Minimum
is 2 and maximum is 10. Once you have the inputs you want, click on the left mouse
button, and the symbol is set. You can now highlight the symbol, and move it horizontally
but only horizontally. (You have to click and hold the button on)
Place one AND gate with 2 inputs and one AND gate with 4 inputs on the program
page.
© Saia-Burgess Controls Ltd. Page 4E-2