iMC-M_iMC-MP_Operating Instruction - Bedienungsanleitungen ...

iMC-P – Operating Instruction
Spindle - 115/230V output, 3-poles
Use this output connector to directly tap a working spindle without speed control. Use
the delivered mating connector. Maximum load of the relay output is 230 V AC / 6A.
AC-Input - net input module 115/230 VAC, 50 - 60 Hz
The net input module consists of net input socket, net filter, fuse holder and net main
switch. Connect the controller via delivered net cable to a free receptacle. After that
you can switch on the controller with the net main switch.
RS232 (PC) – programming interface
Communication between iMC-P and control PC is realized via a serial interface
(RS232). Use the delivered communication (null modem) cable for connection.
A software protocol realizes the faultless transmission of the ASCII characters.
Therefore it’s necessary that both systems respect the communication protocol:
The connected control PC sends a command which ends with a line end
character [CR, char (13)].
The processor unit quits the execution or storing of a command with the
quitting signal 0[char (48)] or returns an occurred error with an ASCII character
unequal 0.
Data transfer parameters:
- 19200 baud
- 8 data bits
- 1 stop bit
- no parity
page - 16