CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
Section 4 <strong>User</strong> Help Reference<br />
• Insert Point — This command or button will insert a<br />
row below the selected point.<br />
• Delete Point — This command will delete the selected<br />
row. Note that you cannot delete the initial point.<br />
PeakTrak automatically updates the Run Length setting or<br />
scales the other points when you change the number of points<br />
and their duration on the curve.<br />
To close the Gradient Table, click the Edit Gradient button.<br />
See Also: DEFINING A GRADIENT [4.4.5]<br />
4.3.2.5 Peak Collection<br />
Use the Peak Collection buttons to set the collection mode.<br />
• All — Click this button to collect all fluids during a run.<br />
• Peaks — Click this button to collect only eluted peaks<br />
during a run.<br />
• None — Click this button to divert all fluids to the<br />
waste port during a run.<br />
• Tube Volume — You can also specify the Tube Volume<br />
for collected fluids. This volume can be the default<br />
maximum volume (Max option) as entered in the<br />
CONFIGURATION [4.3.10] window, or a method-specific<br />
volume less than the capacity defined by the<br />
CONFIGURATION [4.3.10] window. When using a Foxy<br />
fraction collector or the Fractionation Valve, note that<br />
the actual fraction size may be less if a newly detected<br />
peak causes a tube change, or if you click the Next Tube<br />
button.<br />
• Peak — Type or select the desired volume to be<br />
collected in each tube when the module detects a<br />
peak.<br />
• Non-peak — Type or select the desired volume to be<br />
collected in each tube when peaks are not detected.<br />
This setting allows you to conserve tubes without<br />
diverting non-peak elute to waste. This setting is<br />
ignored when the peak collection mode is set to Peaks<br />
or None.<br />
4-19