CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>CombiFlash</strong> Torrent ®<br />
<strong>User</strong> <strong>Manual</strong><br />
Section 3 Operation<br />
This section provides abbreviated operating instructions for<br />
the <strong>CombiFlash</strong> Torrent module. For complete instructions,<br />
refer to Help menu option from PeakTrak’s main menu.<br />
3.1 Accessory Kit<br />
The Torrent is shipped with an accessory kit (60-5249-002).<br />
Some of the kit components are used during installation.<br />
Other components should be available for use with the system<br />
whenever there is a need to change the configuration. Because<br />
some of these components are needed to match the column and<br />
solid load cartridge cap sizes, Teledyne <strong>Isco</strong> recommends that<br />
you keep the kit near the Torrent.<br />
Key components in this accessory kit are identified in sections<br />
3.1.1 through 3.1.9.<br />
3.1.1 Inlet and Outlet Fittings for Columns and Cartridges<br />
The luer adapters match the inlet and outlet fittings to the<br />
size of the column inlet and outlet. The Torrent was shipped<br />
with fittings matched for 330 gram column sizes and smaller.<br />
When using 750 gram columns or larger, the fittings must be<br />
changed.<br />
To change column luer adapters (top and bottom):<br />
1. Unthread the knurled cap and remove the luer adapter<br />
(Figure 3-1).<br />
2. Align the new adapter with the key in the recess. Ensure<br />
that the adapter is full seated in the recess.<br />
3. Replace the knurled cap<br />
4. Repeat steps 1 through 3 for the other adapter.<br />
3-1