CombiFlash Torrent® User Manual - Isco

Section 2 Preparation
2. Using the two long screws with lock and flat washers,
mount the metal tee fitting on the rear panel, aligning the
two standoffs over the ELSD’s threaded mounting holes,
and the mounting holes in the tee over the two standoffs.
Standoffs (place over
threaded holes)
Figure 2-17 Replace the PEEK tee with the metal tee fitting
3. Locate the 6" piece of tubing. Attach one end to the bottom
of the metal tee fitting and the other end to the ELSD
liquid inlet (refer to Figure 2-19). Tighten fittings to finger,
tight.
4. On the Torrent, disconnect the black PTFE tubing end
from the bottom column connection (Figure 2-18).
2-25