CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
<strong>CombiFlash</strong> Torrent ®<br />
<strong>User</strong> <strong>Manual</strong><br />
Section 6 Maintenance<br />
6.1 System Standby and Shut Down<br />
During extended periods of inactivity, you can place the<br />
system in Standby to conserve power. To do so, log off the<br />
system (File> Log out) and place the On/Standby switch in<br />
Standby .<br />
When in the Standby state, normal system operation is no<br />
longer available from the touch screen or remotely. However,<br />
some internal components are still powered.<br />
WARNING<br />
As long as the AC mains power cord is connected, power is<br />
inside the unit. The mains power cord is the disconnect device.<br />
Position the <strong>CombiFlash</strong> Torrent module so that the power<br />
cord can be unplugged, or use a power strip where the plug<br />
can quickly be removed from the outlet in the event of an<br />
emergency.<br />
When you first place the system in Standby, internal<br />
components continue to operate for almost one minute while<br />
performing file maintenance and preparing the system for<br />
possible power removal.<br />
CAUTION<br />
Removing the AC mains power cord before the file maintenance is<br />
complete might corrupt files on the internal hard drive. These<br />
corrupted files can cause abnormal operation or a complete<br />
system failure that requires service. Unless power must be<br />
removed due to an emergency, always wait at least one minute<br />
after placing the system in Standby before removing the AC mains<br />
power cord.<br />
6-1