CombiFlash Torrent® User Manual - Isco

Section 5 Remote Interfaces
Note
The following instructions may require a user account with
Administrator privileges on the PC. If you cannot modify the
settings in sections 5.2.4 through 5.2.2, contact your Information
Technology department.
5.2.1 Windows 7 Settings
1. From the Windows Start menu, right-click on Network,
then select the Properties menu option. The PC displays
the Network and Sharing Center.
2. Click on the “Change Adapter Settings” link on the left side
of the window.
3. Right-click on the Local Area Connection icon and select
the Properties option. If User Account Control requests
permission to continue, click OK. The PC displays the
Local Area Connection Properties window (Figure 5-1).
4. Select Internet Protocol Version 4 (TCP/IPv4), then click
the Properties button. The PC displays the Internet
Protocol Version 4 (TCP/IPv4) Properties window
(Figure 5-2).
Note
If the Internet Protocol Version 4 (TCP/IPv4) option is not listed,
click the Install button to add it. If assistance is needed, press the
F1 keyboard button to display Windows 7 Help.
Note
The following steps change the local area connection settings. If
the PC must be restored to its original network configuration,
record the present Internet Protocol (TCP/IP) settings now.
5. Select the “Use the following IP address” option.
6. Enter the IP address “192.168.1.200”.
7. Enter the Subnet Mask, “255.255.255.0.”
8. Click the OK button to close the Internet Protocol Version 4
(TCP/IPv4) Properties window. Click the OK button to close
the Local Area Connection properties window.
5-5