CombiFlash Torrent® User Manual - Isco

CombiFlash Torrent® User Manual
(iPod Touch, iPhone, and iPad 1 ) running iOS 4.2 or later. The
PeakTrak app is available for download from the App Store.
Each Torrent requires an active license before using the
PeakTrak app. A license may be ordered from Teledyne Isco
using part number 60-5237-073 which contains the necessary
software on a USB flash drive.
Refer to the instructions supplied with 60-5237-073 to install
the license key and configure the system and mobile digital
devices to support remote control.
Note
Remote communication requires the Torrent and mobile digital
device to share a common network with Wi-Fi access in the
remote locations.
5.2 Direct Connection
A direct connection supports communication between the
Torrent and a single PC that meets the recommendations in
Table 5-1.
This guide provides instructions for Windows 7 (section 5.2.1),
Windows Vista (5.2.2), Windows XP (5.2.3), and Windows 2000
(5.2.4). Refer to the applicable section, then follow the
instructions in section 5.2.5 to complete the direct connection.
Note
A direct connection requires a “crossover” CAT5/6 cable. Standard
CAT5/6 network cables will not work. You can purchase a
crossover cable locally or ask your Information Technology
department to assemble one. You can also order a crossover
cable (part number 480-6545-02) from Teledyne Isco.
Note
These instructions assume that the system is using the factory-set
IP address of 192.168.1.51. You can view the IP address of
system from the Help>About PeakTrak screen.
1. Apple, iPod, iPhone, iPad, and App Store are registered trademarks or service marks of
Apple, Inc., registered in the U.S. and other countries.
5-4