CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
CombiFlash Torrent® User Manual - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Section 4 <strong>User</strong> Help Reference<br />
by selecting the TOOLS>MANUAL CONTROL [4.2.3.3] menu<br />
command.<br />
The configuration window displays four tabs: INSTRUMENT<br />
CONFIGURATION [4.3.10.1], NETWORK CONFIGURATION [4.3.10.2],<br />
and USER PREFERENCES [4.3.10.3], FRACTION COLLECTOR<br />
[4.3.10.4].<br />
4.3.10.1 Instrument Configuration<br />
Solvent Controls<br />
• Add Solvent — Click this button to enter a solvent<br />
name. PeakTrak can store up to 16 solvent names. For<br />
assistance in selecting appropriate solvents, see the<br />
SOLVENT SELECTION TABLE [ON-LINE].<br />
• Remove Solvent — Click this button to open a list of<br />
all entered solvent names. Select the names you want to<br />
remove and then click the OK button.<br />
• Enable Solvent Level Sensing — If this option is<br />
selected, the module will check the solvent levels before<br />
and during a run. PeakTrak will alert you if a solvent<br />
level becomes too low. Note that the solvent level<br />
monitoring option does not control the operation of<br />
Waste Solvent Level monitoring. Waste level sensing is<br />
always enabled at the beginning of a run.<br />
• Minimum Solvent Level — This value is<br />
density-dependent, thus a range is given. To understand<br />
the range, consider that dichloromethane is more dense<br />
than hexane. If the selected range is 1–4, an alert would<br />
be triggered when the dichloromethane falls to about 1<br />
cm above the bottom of the weighted filter. At the same<br />
selected range, an alert would be triggered when the<br />
hexane solvent level falls to about 4 cm above the<br />
weighted filter.<br />
• Waste Level Sensing — The module can detect full<br />
container conditions if the air line is placed in the waste<br />
collection container. If waste level detection is desired<br />
enable the waste level sensing feature (recommended).<br />
Otherwise, uncheck this option to disable this feature.<br />
4-27