Glacier Transportable Sampler - Isco

Glacier Transportable Sampler
Section 1 Introduction
1
5
2
3
4
1 Liquid Crystal Display (LCD) 2 rows by 20 characters
2 Standby Button. When in the Off state the Standby button turns the Glacier on and places it in the
Standby state. In any other state, the Standby button will place the sampler in the Off state.
3 KeyPad
NUMBER Buttons allow you to enter numerical values when prompted by an interactive
screen.
The ARROW Button changes the current selection in an interactive screen. Pressing
the ARROW button causes a different option to blink.
ENTER Button. In an interactive state, the ENTER button accepts the selected
(blinking) option. In non-interactive states, pressing the ENTER button will scroll
through any additional displays.
The STOP Button interrupts the current task and the display reverts to the previous
screen or state. If you press the STOP button while a number-entry screen is
displayed, the Glacier restores the previous value. Pressing the STOP button during
a running program places the Glacier in the Paused state.
Pressing the CALIBRATE Button while in the Standby state takes you to the Calibrate
Sample Volume sequence of the programming.
The GRAB SAMPLE Button allows you to collect a grab sample outside of the programmed
number of samples.
The PROGRAM Button is used for the Glacier One-button Programming.
4 GO Button. Pressing the GO button places the Glacier in the Run state using the current program.
5 Humidity Indicator. Indicates the internal humidity. To protect the Glacier’s internal components,
the desiccant must be replaced when the humidity is completely pink (see section 5.7).
Figure 1-3 Glacier Keypad Buttons
1-4