Glacier Transportable Sampler - Isco

Glacier Transportable Sampler
Section 1 Introduction
The Glacier collects liquid samples and places them in a composite
sample container. The largest standard sample container
will hold 5 gallons (19 liters). A dependable peristaltic pump
delivers the liquid to the bottle. Its pump, coupled with the
non-contacting liquid detector, gives you accurate, repeatable
sample volumes time after time. The liquid detector may also be
used to halt the sampling routine when a full bottle is detected.
At the heart of the sampler is the controller. It is environmentally
sealed (rated NEMA 4X, 6 and IP67) to provide protection
from accidental submersion and long term exposure to high
humidity and corrosive gases. Its tactile keypad and 2 line by 20
character display simplifies operation. In just seconds, the
one-button programming procedure will load the stored program
settings and run the sampling routine.
1.1.1 Typical Applications The Glacier is part of Teledyne Isco’s many automated sampling
solutions which include the Model 3700 and 6700 Series samplers.
This versatile product line meets the demands of:
• NPDES permit compliance
• Pre-treatment compliance
• Stormwater run-off
• Combined sewer overflow
• Sanitary sewer evaluations
• Non-point source sampling
• Biomonitoring
1.1.2 Compatible
Equipment
Compatible Isco devices include:
Isco flow measuring instruments:
• 4100 Series Flow Loggers
• 4200 Series Flow Meters
Non-Isco device interfaces:
• 4-20 mA Input Interface
• Pulse Duration Input Interface
Isco parameter measuring devices:
• Liquid Level Actuator
1-2