6100CR Refrigerated Sampler - Isco

6100CR Refrigerated Sampler
Section 2 Programming
7. If you select YES for setting the clock, the following screen
will appear:
HH:MM MM/DD/YY
HH:MM
8.
RUN DIAGNOSTICS
YES NO
In normal operation, you would select NO. You would RUN
DIAGNOSTICS only if you suspected a problem. NO will
always be flashing. If you select NO, the sampler advances
to Step 18.
The ENABLE MANUAL DIAGS menu gives you the capability
of manually controlling some of the mechanical functions
of the sampler as a diagnostic aid. It provides special
functions to some keys on the control panel for a limited
period of time. Selecting YES will let you move the tower
up and down with the arrow keys. It will also let you move
the valve driver (opens and closes the valves on the sample
bottles) through a sequence with the 0 key and it also
enables you to move the bottle rack through a variable
number of bottle positions (1-24) by entering the number of
positions desired with the number keys on the keypad and
then pressing Enter and Rack Reset. Selection of this
option (YES) allows you access to these capabilities for
only 15 minutes. You will have to reenter the selection if
you wish to continue access to the manual diagnostics.
9. If you need to access the manual diagnostics, select YES at
the following menu. If you select YES from the ENABLE
MANUAL DIAGS, the unit will ask for a pass number on
the next screen.
ENABLE MANUAL DIAGS
YES NO
10.
However, if you have entered the pass number within
approximately the last 20 minutes, ENTER PASSNUM-
BER screen will not appear.
ENTER PASSNUMBER
0000
The correct pass number (6100CR) should be entered with
the number keys at this time. An incorrect pass number
will cause the machine to again ask for the pass number
unless you press the Clear/Exit key.
2-6