D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 3 Single & Multiple Independent Pump Operation
Note
The pump can be set to shut off or not at this limit condition by
pressing softkey C under shutdown. This will toggle this option
to ON.
5. To exit the limit setpoint menu, press the softkey D, PRE-
VIOUS.
6. Once all the limits have been set, press softkey D, PREVI-
OUS, to return to the main menu.
Limits programming
options
In addition to setting the upper and lower limits, the pump also
allows the user to specify whether they want:
• the alarm message displayed
• an alarm to sound when the limit is reached
• the pump to shut down when the limit is reached
These features are set using the softkeys, A-C. Pressing these
softkeys toggle the feature on and off. (If you press the softkey
once the feature is activated, pressing the softkey again turns
the feature off).
Note
The Max Press (maximum pressure) display on and alarm on
options cannot be disabled.
Display
When this feature is on and a limit has been exceeded, the pump
will automatically flash an over or under limit message on the
screen. If you do not wish it to do so, press softkey A once to
toggle this to:
OFF
DISPLAY
Alarm
When this feature is on, the pump will automatically beep a
warning when a limit has been exceeded. If you wish to disable
the beep, press softkey B once. The display should change to:
OFF
ALARM
Shutdown
The pump will, if you wish, shut down [pump stop] when a limit
has been exceeded. If you wish to enable this feature, press
softkey C once. The display should change to:
ON
SHUTDOWN
Flow rate limit for pressure
control
When the pump is controlling pressure (CONSTANT
PRESSURE MODE), the flow rate is not set by the operator, and
may range up to the maximum flow the pump is capable of. In
some cases, it is desired to limit the rate of pumping during
3-15