D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
D <strong>Series</strong> <strong>Syringe</strong> <strong>Pumps</strong><br />
Section 3 Single & Multiple Independent Pump Operation<br />
3.5.3 STORE The store key is operational when in the programmed gradient<br />
mode. It is used to save the program gradient parameters and<br />
exit the programming (parameter entry) mode.<br />
3.5.4 LIMITS The controller allows the user to set the minimum and maximum<br />
flow rate limits, the minimum and maximum pressure limits,<br />
and the maximum rate the pump will run while controlling the<br />
pressure in constant pressure mode.<br />
• When using a single controller to operate multiple<br />
pumps, you need to select the appropriate pump before<br />
setting any pump parameters. The available pumps will<br />
be displayed above the softkeys. These selections correspond<br />
with the connector that the pump control cable is<br />
plugged into on the rear panel of the pump controller. To<br />
select a pump, press the softkey under the pump designation.<br />
The top line of the screen will indicate the pump<br />
which is currently selected.<br />
• The high and low limits you set cannot exceed the pump<br />
specifications.<br />
To set the limits<br />
1. Press the LIMITS key on the keypad. To display the Limits<br />
menu, Figure 3-7, enter the number of the limit you wish<br />
to program using the number keys. This will cause one of<br />
five limit setpoint menus to appear, MAX PRESS, MIN<br />
PRESS, MAX FLOW, MIN FLOW, or FLOW LIMIT. The<br />
MAX PRESS limit setpoint menu is shown in Figure 3-8.<br />
Figure 3-7 Limits menu<br />
LIMITS:<br />
CURRENT PUMP<br />
1. MAX PRESS _____<br />
2. MIN PRESS______<br />
PUMP A<br />
3. MAX FLOW____<br />
4. MIN FLOW_____<br />
5. FLOW LIMIT_____<br />
PREVIOUS<br />
A B C D<br />
MAX PRESS_____PSI<br />
1. SET PRESS VALUE<br />
Figure 3-8 Limits setpoint (Max Press) menu<br />
ON ON OFF<br />
DISPLAY* ALARM* SHUTDOWN* PREVIOUS*<br />
A B C D<br />
Note<br />
These features are discussed later in this section under Limits<br />
Programming Options.<br />
2. Press the number 1 key to set the value. A message will<br />
blink on the right side of the screen, prompting you to<br />
enter the selected limit.<br />
3. Enter the desired limit setpoint, using the number keys.<br />
4. Press the ENTER key to save the value.<br />
3-14