D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 3 Single & Multiple Independent Pump Operation
3.3.5 Display Contrast The pump conveniently allows you to adjust the screen contrast
for your light conditions and viewing angle.
To change the display
contrast
1. Press the orange MENU key.
2. Press number 6, DISPLAY CONTRAST. The display contrast
menu, Figure 3-4, will be displayed.
ADJUST THE DISPLAY CONTRAST:
DEFAULT DOWN UP
PREVIOUS
Figure 3-4 Display contrast menu
A B C D
3. Use softkeys B, DOWN, or C, UP to change the contrast.
Raising the contrast [UP] darkens the blue of the writing.
Note
Due to differences in manufacture, some displays will not show
an obvious variation when the contrast is adjusted. This is normal
and should not be considered a malfunction.
3.3.6 Serial Option The serial option menu allows you to set the baud rate and the
unit identification number.
To change the serial options
1. Press the orange MENU key.
2. Press softkey A, MORE.
3. Press number 1, SERIAL OPTION. The serial option
menu, Figure 3-5, will be displayed.
BAUD RATE = 1200
UNIT # ID = 6
NEXT BAUD
NEXT ID#
PREVIOUS
Figure 3-5 Serial option menu
A B C D
4. Use softkey A, NEXT BAUD, to scroll through the available
baud rates. These are: 300, 1200, 2400, 4800, 9600,
and 19.2K, 38.4K, 57.6K.
5. Use the softkey B, NEXT ID#, to scroll through the available
ID numbers. These are 1-7. Six is the default, as this
is the unit identifier for the Teledyne Isco LabView software.
For a complete discussion of serial control, refer to Section 6 in
this manual.
3.3.7 Pump Status This option simply presents the revision of software used by the
pump controller and indicates the type of pumps connected to the
controller.
3-7