D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 3 Single & Multiple Independent Pump Operation
Note
This option covers all pumps connected to the controller. You
cannot dictate the action of an individual pump.
3.3.4 Resetting the System This option allows you to completely clear user programmed settings.
It will erase all programs and return units and limits to
factory settings. If the ZERO PRESS key has been used, the corrected
offsets will be lost.
Note
This option covers all pumps connected to the controller. You
cannot dictate the action of an individual pump.
Press softkey D, DO_NOT, to return to the main menu without
resetting your system.
CAUTION
Once a system reset has taken place, all programs will be
erased. These cannot be recovered. All user-set limits and
units will be returned to the factory default settings.
System reset
Hard reset
1. Press the orange MENU key.
2. Select number 5. SYSTEM RESET.
3. Press softkey A, CONTINUE.
A hard reset should only be performed when changing EPROMs
for a software upgrade or at the suggestion of the Isco Service
Department. Like the system reset, all user programmed settings
will be cleared.
Note
A hard reset will erase all programs and user defined parameters.
These cannot be recovered.
1. Turn the pump controller to STANDBY.
2. Press and hold the CLEAR ENTRY key on the front panel
keypad.
3. While holding the CLEAR ENTRY key, flip the on/standby
switch to ON. Keep the CLEAR ENTRY key pressed for 1
second.
4. Release the key and turn the unit back to STANDBY.
5. Then turn the instrument back ON and execute a system
reset (described above).
3-6