D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 3 Single & Multiple Independent Pump Operation
The following options are available via the main menu, Figure
3-1. Each option is discussed in the separate subsection indicated.
• Units: Section 3.3.1.
• Refill: Section 3.3.2.
• Power failure: Section 3.3.3.
• System reset: Section 3.3.4.
• Display contrast: Section 3.3.5.
• Serial options: Section 3.3.6.
• Status Section: 3.3.7.
• External analog control: Section 3.3.8.
• Multi-pump mode: Section 3.3.9.
• Total volume reset: Section 3.3.10.
• Valve: Section 3.3.11.
3.3.1 Setting Flow and/or
Pressure Units
For your convenience, the controller allows the user to set the
displayed units on the pump. See Figure 3-2.
PRESSURE UNITS=___________FLOW UNITS=__________
1. ATM
3. PSI
5. mL/MIN 7. µL/MIN
2. BAR
4. kPA
6. mL/HR 8. µL/HR
PREVIOUS
A B C D
Figure 3-2 Units menu
Setting the units
1. Press the orange MENU key.
2. Press number 1, UNITS.
3. The units menu, Figure 3-2, will be displayed.
4. Use numbers 1-4 to select the pressure units (ATM, BAR,
PSI, kPa). Pressing the number associated with the unit
will cause it to be displayed on the first line of the screen
after PRESSURE UNITS=.
5. Use numbers 5-8 (mL/MIN, mL/HR, µL/MIN, µL/HR) to set
the flow rate units. Pressing the number associated with
the unit will cause it to be displayed on the first line of the
screen after FLOW UNITS=.
6. To exit the UNITS menu, press softkey D, PREVIOUS.
This will return you to the main menu screen. Your settings
will be saved automatically for all pumps.
3-4