D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
D <strong>Series</strong> <strong>Syringe</strong> <strong>Pumps</strong><br />
Section 3 Single & Multiple Independent Pump Operation<br />
Line Three – Line three varies depending on the mode; the rate<br />
and units are set by the user, so these will vary depending on<br />
your programming requirements. The ending time will always be<br />
displayed on this line.<br />
Current Pressure<br />
Ending Time<br />
PS/MIN<br />
FINAL:<br />
PSI<br />
00:00:00<br />
Final Pressure<br />
Rate<br />
Line Four – Line four varies depending on the mode. The<br />
options presented on this line are softkey selectable, i.e. you use<br />
the softkeys (A - D) located under the screen to choose the option.<br />
3.2.2 Selecting Operating<br />
Parameters<br />
There are three ways operating parameters are set from a menu<br />
screen, using a softkey or pressing a programming option key on<br />
the controller keypad.<br />
Menu Selection – The number keys are used to make menu selections.<br />
The menu options will be numbered and demarcated by a<br />
period, such as “1. UNITS.” Pressing the number 1 will select the<br />
UNITS option and cause the units menu to be displayed.<br />
Softkey Selection – The softkey selectable programming options<br />
are displayed on the fourth line of the LCD. To select an option,<br />
press the softkey, A-D, directly under the option. The parameter<br />
will either toggle or be selected when the softkey is pressed.<br />
Keypad Selection – The programming keys are located on the<br />
left side of the controller keypad. The pump mode, limits, and<br />
refill are all options that may be selected from the keypad.<br />
Value Selection – The number keys are used to enter all<br />
numeric values required for pump operation. When a numeric<br />
value is required, the controller will usually display a blinking<br />
message, prompting you to enter an appropriate value.<br />
3.3 Main Menu Features The main menu (Figure 3-1) is accessed by pressing the orange<br />
MENU key on the pump controller keypad.<br />
Once it is displayed use the number keys to select a menu option.<br />
Selecting an option from the main menu displays the programming<br />
parameters for that option. These will be presented in<br />
menu form. When the main menu is displayed, press softkey A,<br />
MORE, to view additional programming options. To return to the<br />
run screen press softkey D, RETURN.<br />
1. UNITS<br />
2. SELECT PUMP<br />
3. REFILL<br />
MORE<br />
4. POWER FAILURE [__]<br />
5. SYSTEM RESET<br />
6. DISPLAY CONTRAST<br />
RETURN<br />
A B C D<br />
Figure 3-1 Main menu<br />
3-3
Change language