D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Model 65D
Section 2D 65D Liquid System Connections & Accessories
2D.3 Temperature and
Pressure Controls
2D.3.1
Cylinder Insulating
Cover
An optional insulation cover (P/N 68-1247-081) is available to
reduce noise (due to temperature fluctuations) and also improve
pump performance at flow rates under 500 µl/min.
The cover consists of two pieces which fit over the cylinder, as
shown in Figure 2D-3.
Notches for
tubing
Side Latches
Notch for cable
Figure 2D-3 Cylinder insulation cover
Notches in the cover provide openings for the inlet and outlet
tubing and for the cable to the pressure transducer.
To install the cylinder
insulating cover
(Figure 2D-3)
1. Install the back cover.
2. Route the cable around tubing through the appropriate
tabs.
3. Install the front cover and secure the side latches.
2D-3