D-Series Syringe Pumps - Isco

D Series Syringe Pumps:
Model 65D
Section 2D 65D Liquid System Connections &
Accessories
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 1379 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
2D.1 Introduction This section discusses liquid system connections in general, and
details the accessory package installation. It also covers the
installation of fluid connection accessories, temperature and
pressure control accessories, optional kits and attachments, and
software options.
2D.2 Fluid Connections
If you are not familiar with syringe pumps, you may wish to refer
to the general information and helpful tips presented in section
2A.2, Liquid System Connections. To proceed directly to your
package installation instructions, use the following references to
locate the desired section.
Fluid Connection Accessories (section 2D.2):
Pump inlet and outlet, 2D.2.1
Drain tube, 2D.2.2
Temperature and Pressure Controls (section 2D.3):
Cylinder insulating cover, 2D.3.1
Cooling jacket package, 2D.3.2
Nitrogen Purge (section 2D.4)
2D.2.1 Pump Inlet and Outlet There are two F250C ports in the pump cylinder cap. The F250C
fittings are designed for use with high-pressure 1 4"–40 tubing.
Either port can serve as the inlet or outlet. As shown in Figure
2D-1, you may plug one port and use a single port as both the
inlet and outlet.
2D-1