D-Series Syringe Pumps - Isco

D Series Syringe Pumps:
Model 1000D
Section 2C 1000D Liquid System Connection &
Accessories
2C.1 Introduction
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 138 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
This section discusses 1000D liquid system connections, in
general. If you are familiar with syringe pumps, you may wish to
skip over the general information and helpful tips presented in
section 2C.2, Liquid System Connections, and proceed directly to
your 1000D package installation instructions. Use the following
reference chart to locate the desired section.
2C.2 Liquid System
Connections
The following section provides general information concerning
1000D syringe pump, some tips about liquid connections and
information about tubing and tubing cutting procedures.
2C.2.1 Ports There are two ports in the cylinder cap. The 1000D ports come
standard with 1 4" pipe thread fittings.
Either port can serve as the inlet or outlet. As shown in Figure
2C-1, you may plug one port and use a single port as both the
inlet and outlet.
2C-1