D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Model 500D
Section 2B 500D Liquid System Connection & Accessories
DANGER
RISK OF INJURY. THE PRES-
SURE PRODUCED COULD BE
260 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND
CONNECTIONS NOTED IN THE
MANUAL.
Figure 2B-4 500D pump outlet valve package installation
2B.4 Temperature and
Pressure Controls
2B.4.1
Cylinder Insulating
Cover
An optional insulation cover (P/N 68-1247-085) is available to
reduce flow noise due to temperature fluctuations and also
improve pump performance at flow rates under 500 µl/min.
The cover consists of two pieces which fit over the cylinder, as
shown in Figure 2B-5.
Notches in the cover provide openings for the inlet and outlet
tubing and for the cable to the pressure transducer.
To install the cylinder
insulating cover
1. Install the back cover.
2. Route the cable around the tubing through the appropriate
tabs.
3. Install the front cover and secure the side latches.
2B-7