D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Model 500D
Section 2B 500D Liquid System Connection & Accessories
4. Then connect the PTFE tubing (with the filter) to the bottom
port of the valve, using the valve fittings,
or,
When connecting to pressurized sources, use the stainless
steel tubing without a filter. Due to the wide variety of
pressure sources, fittings to connect to the pressurized
source are not provided.
2B.3.2
Manual Outlet Valve
Package
The manual outlet valve package is rated to 689.5 bar. It includes
those items necessary to connect a shut-off valve between the
pump and your system process. Table 2B-3 lists the contents of
the package. Figure 2B-4 illustrates the installation.
To install outlet valve
package
1. Attach the valve to the pump tower, using the valve spacer
and screws provided.
2. Screw the male adapter (P/N 209-0161-01) into the pump
outlet.
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 260 BAR. PLEASE UTILIZE THE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
3. Connect the pre-bent tubing from the male adapter to the
valve, using the nuts and ferrules provided.
4. Connect the 1.5 m piece of stainless steel tubing to the bottom
port of the valve, using the fittings provided. This
piece of tubing should be cut to the proper length for connection
to your process system. Due to the wide variety of
applications this pump is used for, fittings to connect this
tubing to your system are not provided.
2B-6