D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Model 500D
Section 2B 500D Liquid System Connection & Accessories
Note
The drain tube shown in this photo may appear slightly different
than that on your pump.
Figure 2B-2 Drain tube installation
2B.3 Fluid Connection
Accessories
The optional accessories discussed in this section are used to make
fluid connections from the 500D pump to another apparatus.
When making fluid connections, be sure to use the ferrules provided
in the connectors. Then push the tubing completely into
the connector and finger tighten. Then tighten with a wrench to
clamp the ferrules on the tubing.
2B.3.1 Manual Refill Kit The manual refill valve package is rated to 689.5 bar. It includes
those items necessary to connect to pressurized or non-pressurized
refill sources. Table 2B-2 lists the contents of the
package. Figure 2B-3 illustrates the installation of the package.
To install the refill kit
1. Attach the valve to the pump tower using the valve spacer
and screws provided.
2. Screw the male adapter (P/N 209-0161-01) into the inlet
port of the pump.
3. Connect the pre-bent tubing from the valve to the male
adapter, using the nuts and ferrules supplied.
2B-4