D-Series Syringe Pumps - Isco

D Series Syringe Pumps:
Model 500D
Section 2B 500D Liquid System Connection &
Accessories
2B.1 Introduction
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 260 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
This section discusses 500D liquid system connections, in
general, and details the accessory package installation. It also
covers the installation of fluid connection accessories, temperature
and pressure control accessories, optional kits and attachments,
and software options.
If you are familiar with syringe pumps, you may wish to skip
over the general information and helpful tips presented in
section 2B.2, Liquid System Connections, and proceed directly to
your 500D package installation instructions. Use the following
reference chart to locate the desired section.
Note
When operating the pump at flow rates at or below 100 µl/min,
it is strongly suggested that a cylinder insulating cover be
installed. See section 2B.4.1.
Fluid Connection Accessories (section 2B.3):
Refill kit, 2B.3.1
Temperature and Pressure Controls (section 2B.4):
Cylinder insulating cover, 2B.4.1
Cooling/heating jacket, 2B.4.2
Nitrogen Purge (section 2B.5)
Optional Accessories (section 2B.6):
2B-1