D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Models 65DM, 100DM, 100DX, 260D
Section 2A 65DM, 100DM, 100DX, and 260D Liquid System Connections & Accessories
2A.4 Temperature and
Pressure Controls
2A.4.1
Cylinder Insulating
Cover
An optional insulation cover (P/N 68-1247-081 for
260D/100DM/DX; 68-1247-085 for 500D) is available to reduce
noise (due to temperature fluctuations) and also improve pump
performance at flow rates under 500 µl/min.
The cover consists of two pieces which fit over the cylinder, as
shown in Figure 2A-8.
Notches for
tubing
Side Latches
Notch for cable
Figure 2A-8 Cylinder insulation cover
Notches in the cover provide openings for the inlet and outlet
tubing and for the cable to the pressure transducer.
To install the cylinder
insulating cover
(Figure 2A-8)
1. Install the back cover.
2. Route the cable around tubing through the appropriate
tabs.
3. Install the front cover and secure the side latches.
2A-10