D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Models 65DM, 100DM, 100DX, 260D
Section 2A 65DM, 100DM, 100DX, and 260D Liquid System Connections & Accessories
ferrule. Connect the other end to the top port on the valve
using the valve fitting.
Note
When nuts are torqued to the cylinder cap ports, the pressure
reading may be affected. If the pressure no longer reads zero,
push pressure zero key on the front panel of the controller to
readjust.
3. Then use the valve fittings to attach the 5.1 cm length of
1 8" OD stainless steel tubing to the port of the 2-way valve.
4. Connect the reducing union, (P/N 209-0162-00) to this 5.1
cm tubing.
5. Connect the 0.9 m length of 1 16" tubing between the reducing
union and your apparatus. Cut to the desired length.
DANGER
RISK OF INJURY. THE PRES-
SURE PRODUCED COULD BE
700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND
CONNECTIONS NOTED IN THE
MANUAL.
Figure 2A-6 Outlet valve package connection
2A.3.4 In-Line Filter Package The optional in-line filter package (P/N 68-1247-011) should be
used when it is important to filter flow exiting the pump. This
package (Table 2A-4) contains a 0.5 µm filter and 1 16" tubing.
2A-8