D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Models 65DM, 100DM, 100DX, 260D
Section 2A 65DM, 100DM, 100DX, and 260D Liquid System Connections & Accessories
2A.2.4 Accessory Package The accessory packages for all pumps (#60-1249-012 for 260D,
#60-1249-028 for 65DM, or #60-1249-015 for 100DM/DX) contain
Valco fittings for 1 8" tubing, which allow you to attach tubing to
the pump, a reducing adapter for use with 1 16" tubing, and the
appropriately sized cylinder seals.
To install the 1 8" fittings
(Figure 2A-2)
1. Slide first the 1 8" nut and then the ferrule over the tubing.
2. Push the tubing all the way into the port.
3. Then hold the tubing in place and tighten the nut.
DANGER
RISK OF INJURY. THE PRES-
SURE PRODUCED COULD BE
700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND
CONNECTIONS NOTED IN THE
MANUAL.
209-0166-80
Figure 2A-2 Accessory package installation
To install the 1 16" fittings
1. The reducing adapter must be used. Loosen the 1 16" nut
until it is held by a few threads.
2. Insert the adapter into the port and finger tighten the fittings.
3. Retighten the 1 16" nut until it is also finger tight.
4. Tighten the 1 8" nut with a wrench to crimp the ferrule.
5. Insert the 1 16" tubing through the 1 16" nut until it stops.
6. Tighten the 1 16" nut.
Note
It is recommended that after tightening, the fittings be removed
and examined.
2A.2.5 Drain Tube The overflow outlet on the pump cylinder provides a means of
draining fluid from seal leakage. Use the 1 4" ID flexible tubing
included with the accessory package, to divert the leakage away
from the pump. To install the drain tube, simply place one end of
the tubing over the end of the drip pan outlet, shown in Figure
2A-3.
2A-4