D-Series Syringe Pumps - Isco

D Series Syringe Pumps: Models 65DM, 100DM, 100DX, 260D
Section 2A 65DM, 100DM, 100DX, and 260D Liquid System Connections & Accessories
Note
When operating at flow rates at or below 100 µl/min, it is
strongly suggested that an insulating cover or cooling jacket be
installed. See Temperature Controls in the following list.
Fluid Connection Accessories (section 2A.3):
Pump refill kit, 2A.3.1
CO 2 cylinder connection package, 2A.3.2
Outlet valve package, 2A.3.3
In-line filter package, 2A.3.4
Temperature and Pressure Controls (section 2A.4):
Cylinder insulating cover, 2A.4.1
Cooling jacket package, 2A.4.2
Back pressure regulators, 2A.4.3
Nitrogen Purge (section 2A.5)
Optional Kits and Instrumentation (section 2A.6)
Optional Seal Selection (section 2A.7)
Optional Accessories (section 2A.8)
2A.2 Liquid System
Connections
The following section provides general information concerning
syringe pumps, some tips about liquid connections, and information
about tubing and tubing cutting procedures. The
accessory package is also discussed.
2A.2.1 Ports There are two ports in the pump cylinder cap. Either port can
serve as the inlet or outlet. As shown in Figure 2A-1, you may
plug one port and use a single port as both the inlet and outlet.
DANGER
RISK OF INJURY. THE PRES-
SURE PRODUCED COULD BE
700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND
CONNECTIONS NOTED IN THE
MANUAL.
Pressure
transducer cap
Nut &
Ferrule
Port
Plug
Port
Tubing
to valve
Figure 2A-1 Liquid system plumbing connections
2A-2