D-Series Syringe Pumps - Isco

D Series Syringe Pumps:
Models 65DM, 100DM, 100DX, 260D
Section 2A 65DM, 100DM, 100DX, and 260D
Liquid System Connections & Accessories
About This Section:
The following section is divided into four parts, 2A through 2D. Section 2A covers the liquid
system connections and accessories for the Teledyne Isco 65DM, 100DM, 100DX, and 260D
syringe pumps. Sections 2B, 2C, and 2D cover the same topics for the 500D, 1000D, and 65D
syringe pumps, respectively.
The installation procedures for the D Series pumps have been divided in this way for your convenience.
The 65DM, 100DM, 100DX, and 260D pumps all come with 1 8" standard Valco ports. The
500D and 1000D ports are 1 8" pipe thread fittings. The 65D uses AE F250C high pressure fittings.
Because of this difference, the packages, tubing, and options have different part numbers. Additionally,
these pumps are typically used for different applications; therefore, the optional kits and
accessories differ.
Table 2A-6 is a seal selection chart applicable to all D Series pumps except the 65D.
If you are setting up flow gradient, continuous flow, air valve, or modifier addition systems, there
are sections for these systems located at the rear of this manual, which contains plumbing suggestions
and outlines basic operation.
DANGER
RISK OF INJURY. THE PRESSURE PRODUCED
COULD BE 700 BAR. PLEASE UTILIZE
APPROPRIATE TUBING AND CONNECTIONS
NOTED IN THE MANUAL.
2A.1 Introduction This section discusses liquid system connections in general, and
details the accessory package installation. It also covers the
installation of fluid connection accessories, temperature and
pressure control accessories, optional kits and attachments, and
software options.
If you are familiar with syringe pumps, you may wish to skip
over the general information and helpful tips presented in
section 2A.2, liquid system connections, and proceed directly to
your package installation instructions. Use the following references
to locate the desired section.
2A-1