D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 1 Introduction
1.5 Preliminary Checkout After the electrical connections have been completed, follow this
brief test of the pump’s operation:
Note
Preliminary checkout of the pump is performed without fluid in
the pump.
Note
If adding a new pump to the controller, a hard and soft reset
need to be completed.
1. Before connecting the line cord, make sure the voltage rating
on the serial tag matches your outlet’s voltage. Plug in
the line cord. Set the pump mains power switch to ON. Set
the controller ON/STANDBY switch to ON.
2. The display will briefly show the software revision on the
first line; and the pump model(s) connected to the controller
on the following lines, Figure 1-9.
PUMP CONTROLLER ISCO, INC. REV ______
Figure 1-9 Status Screen
3. Check the upper left corner of the controller screen. The
current pump mode will be presented in a two-letter abbreviation,
e.g. CF for constant flow. This will be followed by a
lowercase letter indicating the current pump, e.g. lowercase
“a” indicates that pump A is the current pump. The
current pump is the one for which parameters are being
set.
a. If a pump other than pump A is currently selected:
On the lower right corner of the screen, directly over
softkey D, are the words “SELECT PUMP.”
Press softkey D and then softkey A to select pump A.
The display will automatically switch to the run screen,
and “a” will be displayed in the upper left corner.
4. Press the orange MENU key on the controller front panel.
5. Press number 6 to set the display contrast. Use softkeys B
and C to set the optimum contrast for your viewing conditions.
Press softkey D, PREVIOUS, to return to the menu
screen.
6. Press number 1 to select UNITS.
7. Press number 3 to select PSI for the pressure units.
8. Press number 5 to select ML/MIN for the flow units. The
first line of the display will show the selected units.
1-17