D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 1 Introduction
1.3 Unpacking After removing the pump, controller, and accessories from the
shipping carton, examine them for signs of shipping damage. Be
sure no internal parts have shaken loose in transit. If there is
any shipping damage, file a claim with the delivering carrier
immediately.
Compare the contents of the boxes with the enclosed packing
slip. If there are shortages, contact Teledyne Isco immediately.
1.4 Electrical Connections The pump controller may be placed on top of the pump, as shown
in Figure 1-1. Power is supplied to the pump controller through
the control cable.
CAUTION
All connections between the pump and controller should be
made BEFORE the pump is connected to mains power.
1. Connect the pressure transducer cable (which originates
from the top of the pump cylinder) to the nine pin sub-D
PRESSURE TRANSDUCER connector on the pump rear
panel (Figure 1-7). Be sure to tighten the thumbscrews.
2. Connect the control cable (which originates from the pump
rear panel) to the PUMP A connector on the rear panel of
the controller (Figure 1-6), and tighten the thumbscrews.
This cable must be plugged into the PUMP A connector.
Important
There are three PUMP connectors on the rear of the controller.
Only the PUMP A connector is wired to supply power to the
controller; therefore, one pump must be attached to this connector.
3. Check the serial number tag to make sure the voltage rating
of the pump is correct.
4. Connect the line cord to the MAINS connector on the back
of the pump.
1-16