D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 1 Introduction
60-1242-306
Figure 1-7 Pump rear panel connectors
Table 1-11 Pump Rear Panel Connectors
Item No. on
Figure 1-7
Connector
Description
1 Pressure outputs Two red binding post/banana jacks providing pressure output voltages.
Pump Left Jack Right Jack
VDC/psi VDC/psi
65D 1.0 V/2000 psi 0.1 V/2000 psi
All others 1.0 V/1000 psi 0.1 V/1000 psi
2 Ground A black binding post/banana jack providing a connection to circuit
common.
3 Pressure transducer The pressure transducer cable must be plugged in for the pump
to operate.
4 Control cable This cable connects the pump to the controller.
5 Mains IEC power connector with EMI filter.
6 Fuses * Limits pump current drawn from main power supply.
Replace with same type: (“T” time delay fuses)
1 - 2.0 Amp for 100/117 volt operation
2 - 1.0 Amp for 234 volt operation
To remove, rotate cap counterclockwise.
7 Chassis ground Ground point for high static installations.
* Fuses not replaceable
by the operator
F101 4.0 Amp “T”
F102, F104 1.5 Amp “T”
F103 0.75 Amp “T”
1-14