D-Series Syringe Pumps - Isco

D Series Syringe Pumps
Section 1 Introduction
POWER REQUIREMENTS a
(Mains voltage line cord is a
“Disconnect Device”)
LINE FREQUENCY
Table 1-5 260D Technical Specifications
100 ± 10 Vac, 1.5 A maximum
117 ± 12 Vac, 1.5 A maximum
234 ± 23 Vac, 0.75 A maximum
50 or 60 Hz
}
Factory Set
LINE VOLTAGE NOISE TOLERANCE
1.7 nominal rms line voltage, 10 µsecond pulses, any phase
angle, random or repetitive
DIMENSIONS PUMP CONTROLLER
Width: 27.18 cm 27.18 cm
Depth: 46.74 cm 30.48 cm
Height: 101.09 cm 13.59 cm
WEIGHT PUMP CONTROLLER
32.8 kg 2.96 kg
FLOW RATE RANGE See Figure 1-2.
FLOW RATE ACCURACY b
FLOW RATE DISPLAY RESOLUTION
ANALOG OUTPUT ACCURACY c
DISPLACEMENT RESOLUTION
REFILL TIME
REFILL OR DEPRESSURIZATION RATE
PRESSURE RANGE
PRESSURE ACCURACY
PRESSURE REPEATABILITY d
ZERO PRESSURE DRIFT
PRESSURE DISPLAY RESOLUTION
± 0.5% (maximum 0.50 µl/min seal leakage)
1.0 µl/min
± 1% of selected range
16.63 nl
2.5 minutes
1.0 µl/min to 107 ml/min at any pressure from 0 to 517.1 bar
0.6895 to 517.1 bar
± 0.5% of full scale at constant temperature
± 0.5% of full scale within 48 hours at constant temperature
± 0.25% of full scale within 48 hours at constant temperature
6.895 kPa
AMBIENT TEMPERATURE RANGE 5 to 40°C
TEMPERATURE DRIFT
HUMIDITY
CYLINDER CAPACITY
DEAD (HEADSPACE) VOLUME e
± 0.15% of full scale/°C
95% maximum
266.05 ml
2.10 ± 0.020 ml
POLLUTION DEGREE 2
INSTALLATION CATEGORY
MAXIMUM ALTITUDE
II
2000 m
a. Underwriters Laboratories (UL) has certified all D Series Pumps with the exception of the 100 Vac versions.
b. Using water at 137.9 bar and a temperature controlled environment at 30°C.
c. The analog output is an optional accessory.
d. Pressure repeatability specification is based upon re-zeroing pressure transducer every 48 hours. Refer to sub-section
ZERO PRESS in Section 3 of the manual for re-zeroing procedure.
e. Volume in and above the piston seal, head clearance at automatic shutoff, and inlet and outlet ports to the fittings.
1-6