D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
D-Series Syringe Pumps - Isco
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
D <strong>Series</strong> <strong>Syringe</strong> <strong>Pumps</strong><br />
Section 8 Continuous Flow Introduction, Installation, & Operation<br />
8.6 Operation Once your valve package has been properly installed and you<br />
have insured that fluid connections are leak free, you are ready<br />
to begin operating your system.<br />
Note<br />
Teledyne <strong>Isco</strong> convention is to name the pumps “pump A” and<br />
“pump B,” reading from left to right.<br />
Before running in continuous flow mode, become familiar with<br />
independent mode, which allows the controller to operate two<br />
pumps independently and simultaneously. You must operate the<br />
two pumps manually for initial setup, i.e. refill and purging of<br />
air. If the Teledyne <strong>Isco</strong> air valve package is used, the air valves<br />
are switched through the “ACCESS CTRL” key. Lights on the air<br />
switches indicate which valves are open.<br />
8.6.1 Continuous Flow Setup Continuous flow mode is found under the multi-pump options on<br />
the second page of the main menu (MORE). Once you have<br />
accessed the multi-pump options you may select continuous flow<br />
- constant flow mode or constant pressure mode.<br />
To set up continuous<br />
constant flow<br />
To set up continuous<br />
constant pressure<br />
1. Press the orange MENU key on the controller front panel.<br />
2. Press softkey A, MORE, to access the second page of the<br />
main menu.<br />
3. Press the 4 key on the numeric keypad to select number 4.<br />
MULTI-PUMP. The multi-pump menu will then be displayed.<br />
4. Press the 1 key on the numeric keypad to select 1. CON-<br />
TIN CONST FLOW. The 1. will blink, indicating that the<br />
controller is set to this mode.<br />
5. Press softkey D, PREVIOUS, three times to return to the<br />
run screen.<br />
The controller has now automatically set the pump to continuous<br />
constant flow mode.<br />
1. Press the orange MENU key on the controller front panel.<br />
2. Press softkey A, MORE, to access the second page of the<br />
main menu.<br />
3. Press the 4 key on the numeric keypad to select number 4.<br />
MULTI-PUMP. The multi-pump menu will then be displayed.<br />
4. Press the 2 key on the numeric keypad to select 2. CON-<br />
TIN CONST PRESS. The 2. will blink indicating that the<br />
controller is set to this mode.<br />
5. Press softkey D, PREVIOUS, three times to return to the<br />
run menu.<br />
The controller is now set to continuous constant pressure mode.<br />
8-17